esphome-lg-controller icon indicating copy to clipboard operation
esphome-lg-controller copied to clipboard
verified publisher icon JanM321

Seeed Studio XIAO ESP32-C6 target

Open ireun opened this issue 3 months ago • 5 comments

Hi!

I've started my work of porting featherboard design to fit Seed Studio XIAO ESP32-C6

Changes:

  • TestPoints (GND, 3V3, 12V)
  • Additional Cap C3 on 3V3 output of TPS82130
  • Ability to mount XIAO directly or through header
  • 2 layers only
  • Signal pin is in the middle of JST connector
  • Added a place for an IR diode, making it possible to use it when some functions are unavailable to set by CN-REMO but are available to and IR remote
Image Image Image

Let me know what you think :)

ireun avatar Sep 10 '25 12:09 ireun

Very nice - I was wondering if there is IR protocol for air-water HP ThermaV available?

martiinezz avatar Sep 22 '25 07:09 martiinezz

@martiinezz I have no idea, you may look at https://www.esphome.io/components/climate/climate_ir/ or record original IR remote using IR receiver, and relay these messages later (https://www.esphome.io/components/remote_receiver/) :)

ireun avatar Sep 22 '25 14:09 ireun

Hi @ireun, Have you ordered the PCB's? And if so, does it work? can you share the files you have made? :)

Vincentb19 avatar Nov 02 '25 15:11 Vincentb19

Hi @Vincentb19 sadly no, i've order 'mini' board, but my LG HVAC - P12EN does not support external wired controller.

I'll try to find the files and upload them, will ping you back ;)

ireun avatar Nov 02 '25 16:11 ireun

@Vincentb19 Hi! I've published the files here: https://github.com/ireun/esphome-lg-controller/tree/main/hardware-SeeedXiaoC6

Keep in mind that I have not tested this, I have not prepared gerber files. Most importantly I will probably never gonna 'finish' this. I just 'think' it should work. :)

ireun avatar Nov 12 '25 14:11 ireun