GUI - VLAN

Open jsconsultancy opened this issue 8 years ago • 2 comments

Hi,

I've tried configuring the VLAN on the GUI but after I save and reboot, the config reverts back to default settings. I've tried using original Shibby tomato firmware 140 and the problem doesn't exists for Shibby. So it looks like it's basically a GUI problem.

Nov 12 '17 07:11 jsconsultancy

I'm not really sure how this could be a GUI issue. Its really hard to pinpoint the issue, specially when you don't even mention the router you are using.

Nov 12 '17 11:11 Jackysi

If you're using an Asus router then you probably need to run these commands

nvram set manual_boot_nv=1 nvram commit

Mar 22 '18 12:03 ghost