Horgul123
Horgul123
@Selberg666 : I've added a comment at printables. :) I was able to install it, but need to do some modifications to avoid drilling a hole in the K1. And...
> Yeahhhhh straighten the filament ad much as possible and then try to insert it......major design flaw in the sensor.....if the filament isn t straight it goes sideways after you...
in my cgf I have switch_pin: !PC15 You don't invert the signal. I would expect that if you use the wrong version, it immediatly stops and throws an error.... strange
Ah ok. I'll test it as I'm getting many pause during the current print Am So., 4. Feb. 2024 um 17:38 Uhr schrieb Selberg666 < ***@***.***>: > With ! I...
Changed my settings but still getting false positives :(
@The-last-phantom at the moment have 4.5mm and still a stop in the middle of the night. My fear is: if I increase it too much a real error could be...
Ok. Thanks for the explanation. Then I will try to increase the detection length a little bit more.
> Can I connect the sfs where the stock filament sensor is connected? Yes, but you can one use the runout OR the motion sensor, as you have only one...
@Apollon77 Unfortunately not. It happens just from time to time. At the moment it's not happening anymore, even after a restart which showed this error every time during my last...
Ah ok. Glaub ich Dir sofort, dass das nicht ganz einfach ist. Die einfach zu ignorieren, damit es nicht zu Abbrüchen kommt, geht nicht? Oder im Log ein Hinweis, dass...