Hidvegi82

Thanks for the reply. I understand and I'm sorry if I asked wrong. Wouldn’t it be possible to have a height value that I reset on the ground (or start...

Thank you very much!!!

Both use the factory NEO 6M (TX-IO34, RX-IO12). Interestingly, one of the motherboards worked with the same software version before.  

Yes, I noticed. The problem is that it previously worked with the same version and the same configuration file. This OGN (T22_V1.0) worked with the following configuration files for several...

**Does the GPS start flashing the PPS after a while when exposed to the sky?** Yes, if I don’t use it for a long time, for a few minutes, but...

Ok, I'll ask them. Maybe this information may be important later ... Thanks for the help !!!

Hi I contacted support of the other program. I quote their answer: "Meshtastic changes the GPS to run in UBX mode. The other SW needs NMEA mode. @eriktheV-king has made...

Thank you very much, it works! Just one more question, sorry... Can I change the time zone? (It is here utc+2h)

Yes, i did connect 2 resistors from battery port to GPIO#36, and now, i can see the correct voltage and percent.  "Time zone on the OLED ? No, it...

Hi I tested the changes today, but the gpio36 still needed the resistor divider. Then you sent the correction (in section ADC), and now it works perfectly. Tomorrow I'm doing...