GregValiant
GregValiant
I'm going to go ahead and close this as I have nothing to investigate. I hope you understand.
Thanks for the report. Without a Project File there isn't really anything for us to trouble-shoot. Off the top of my head it looks like a setting issue as I've...
I use whatever partial roll I have laying around for these little test prints and today it happened to be PETG. The changes I made to the file were to...
I'm going to go ahead and close this. We can always re-open it. My thinking is that I just haven't seen this behavior either in my own prints or in...
@lvanek23 we will need a project file to re-open.
@rafaelmontserrat I was going to revisit this but the DownLoad Link has expired and I had deleted the original project file. If you and @lvanek23 could provide new project files...
Without project files this is impossible to chase down. I don't get the problem with my printer so I can't troubleshoot here. Enough of you have posted pictures that there...
@LastDragon-ru Thanks for the file. I sliced your file "as is" with the following exceptions. I commented out the "linear advance" and "ABL" commands from the StartUp section of the...
Oh, before I forget. You have a G28 in your Ending Gcode. That might be fine depending on how the printer Auto-Homes but dropping the Z with a part on...
**_(seems most likely this is a hardware problem?)_** I have my suspicions about that. This problem has been reported several times (as you can see here) but I've not really...