IT8951

This Python 3 module implements a driver for the IT8951 e-paper controller, via SPI. The driver was developed using the 6-inch e-Paper HAT from Waveshare. It hopefully will work for other (related) hardware too.

To install, clone the repository, enter the directory and run

pip install -r requirements.txt
pip install ./

Make sure that SPI is enabled in raspi-config.

For some examples of usage, take a look at the integration tests.

Notes on performance

VCOM value

You should try setting different VCOM values and seeing how that affects the performance of your display. Every one is different. There might be a suggested VCOM value marked on the cable of your display.

Data transfer

You might be able to squeeze some extra performance out of the data transfer by increasing the SPI clock frequency. The SPI frequency for transferring pixel data is by default set at 24 MHz, which is the maximum stated in the IT8951 chip spec here (page 41). But, you could try setting higher and seeing if it works anyway. It is set by passing the spi_hz argument to the Display or EPD classes (see example in tests/integration/tests.py).

Hacking

If you modify spi.pyx, make sure to set the USE_CYTHON environment variable before building---otherwise your changes will not be compiled into spi.c.

Running the code on Linux desktop

You can run this library on desktop Linux distributions (e.g. on Ubuntu) using a "virtual" display, for testing and development. Instead of appearing on a real ePaper device, the contents will be shown in a TKInter window on the desktop. For an example, see the integration tests at test/integration/test.py when passed the -v option.

Windows is curently not supported (the cython build will fail because the C code depends on some Linux components). It might work if you use some Linux compatibility layer like WSL or Mingw.

To get it working first install pillow with pip. Do not install RPi.GPIO (it is only for the Pi, on desktop it will just exit with an error). You may also need the following dependencies (on Ubuntu + related):

sudo apt-get install python3-dev
sudo apt-get install python3-tk

Finally, you need to compile the Cython code. From the IT8951 directory you can either do

python setup.py build_ext --inplace

to build the files right in the source tree, or actually install the package with

pip3 install ./

Now you should be able to run the tests with the -v flag: python test.py -v.

Contributors

Thanks to the following folks for helping improve the library:

• @BackSlasher
• @cetres
• @azzeloof
• @matyasf
• @grob6000
• @txoof