Frix-x
loosing z offset when pause / resume
Klippain branch
- [X] I confirm using the main branch
Version
V4.02
Describe the bug and expected behavior
I Hello! I am a new user of Klipper and am absolutely thrilled :) Thank you for the good work.
I have a question. I want to perform the auto Z calibration only once, and for the subsequent prints, I want to keep the Z offset so that it overrides the auto Z calibration when i start the Print. When I save the determined Z offset via MainSail, I get this message '' .
Additional information and klippy.log
No response
" SAVE_CONFIG section 'stepper_z' Option 'position_endstop' conflicts with included value "
Don't use save config. You have to manually update the new offset in overrides
However with autoz you should be adjusting switch offset. Nothing else.
@tobi466 have you used the manual of auto z? It seems you haven't followed it correctly. What Eric says is the essence and use case of auto z
Alright, I will read the instructions again and try to understand. I have one problem remaining. Every time I pause the print and resume, I lose my Z offset. Is this known with Klippain?
📌 This issue has been marked as stale because it has not had activity in the past 30 days. To keep it open, please respond to this message or add new information. Otherwise, this will be closed in 14 days. Thank you for your contributions!
![github-actions[bot] avatar](https://avatars.githubusercontent.com/in/15368?v=4 "Published by a pub.dev verified publisher"){kind=small}
Hi, i want to contribute on this one. I cannot use pause because i loose some part of the gcode, and/or the Z reference. Below are two pictures: in a paused state, and in another paused state with a clear view on lost gcode + under extrusion due to bad Z position.
First pause
Second pause
Little wad on the lower right corner seems to indicate this is a Z position error, and some filament has been collected on the nozzle and dropped in one time.
after some deeper search, the problems seems to come with the integration with Mainsail, and not directly related to Klippain.