FreeJoyConfiguratorQt

FreeJoyConfiguratorQt copied to clipboard

Request to add more shift modificators

1

I would love to see more shift modificators to be programmed in FJQT. Currently there's only 5 modificators. I have a 8-position rotary switch, that I would like to set...

p33t-r

mlx90363 does not work

1

Hi, the configurator does not recognize the mlx90363 magnetometer, i can select it from the pin configuration but it does not appear in the axis configuration.  

stdevNorge

freejoy configurator support for a shift register shield for electronic newbies

1

G'day This is not so much an 'issue' as a question out of curiosity (& hope) to propose to the developers. I am building a small shield PCB with some...

OzGadget

I built a button box with 17 buttons, setup the pins in configurator, changed the name to 'Button Box', wrote the config to the device, verified in configurator that the...

isawben

About encoders bug& optimization

2

FJ is a great software. I like it very much and always use it to make controllers. I recently found a problem with the encoder. Although I can solve it...

uwlftoe17

Cant connect bluepill board to FreeJoyConfiguratorQt

8

I flashed the firmware using the ST-LINK Utility then plugged into my computer. Windows starts setting it up and it shows up as FreeJoy v1.7.1 in FreeJoyConfiguratorQt but it shows...

Masonator3000

Compile on macosx

2

Hello, when I try to compile from source I get this error 👍 `Undefined symbols for architecture x86_64: "_hid_close", referenced from: HidDevice::processData() in hiddevice.o HidDevice::flashFirmwareToDevice() in hiddevice.o HidDevice::readConfigFromDevice(unsigned char*) in...

FrancescoTalotta

After Config send, Blue Pill not right detected

11

Hello, ich have the problem that after sending the Config the Board is not right detected in FreJoyConfiguratorQt. It was detected as " ONLY FLASH". When i push the Reset...

eviltheknivel