Octolapse

Octolapse copied to clipboard

Stabilization issue after upgrade to octopi 0.17/octoprint 1.5.2/python 3/octolapse 4.1

19

#### If this is a feature request describe it here ___REPLACE_THIS__FEATURE_REQUEST_DESCRIPTION_GOES_HERE #### Version of Octolapse Octolapse Version: 0.4.1 #### Version of OctoPrint OctoPrint Version: 1.5.2 #### When you ran into...

ajdavids

Hello, I installed Octolapse on my PI and I had a problem with the light flickering. After searching, I realized a problem with the settings, but I could not open...

DavidFpv

Installation problems

4

Hello, I have been trying to install octolapse for days, unfortunately, always with negative results Version of Octolapse Octolapse Version: I try to install the v0.4.1 #### Version of OctoPrint...

ilmelo92

Use a LED as "flash" for the snapshots

8

I am fairly new to scripting and all, so i hope you can help me out. The plan is to fire a strip of LED's just before the snapshot and...

sqweezr

[Request] Add setting to take multiple snapshots per layer

3

#### Add setting to take multiple snapshots per layer Some of my prints are topo maps which are very wide but only 30-40 layers tall. Currently 1 snapshot per layer...

ansonl

Will not install 'gcc' failed

7

#### If this is a feature request describe it here ___REPLACE_THIS__FEATURE_REQUEST_DESCRIPTION_GOES_HERE #### Version of Octolapse Octolapse Version: 1.7.3 #### Version of OctoPrint OctoPrint Version: 0.4.1 #### When you ran into...

Brodieman

Unable to save printer profile when PrettyGCode is installed

5

#### If this is a feature request describe it here #### Version of Octolapse Octolapse Version: Octolapse 0.4.0 #### Version of OctoPrint OctoPrint Version: 1.4.2 #### When you ran into...

MicrowaveJak

[Request]

10

#### If this is a feature request describe it here can a profile for the Vyper be added under anycubic. #### Version of Octolapse Octolapse Version: ___REPLACE_THIS__OCTOLAPSE_VERSION_GOES_HERE #### Version of...

mbell90

Extruder retracting filament back to the extruder gear.

5

#### Version of Octolapse Octolapse Version: Octolapse 0.4.1 #### Version of OctoPrint OctoPrint Version: OctoPrint 1.7.3 #### When you ran into the problem, did you have diagnostic logging enabled? Diagnostic...

Viper5343

[BUG] Octolapse mistakenly enables vase mode

1

#### Bug description Octolapse mistakenly thinks "vase mode" is enabled because not all cura related settings to this mode are taken into account. For "vase mode" both magic_spiralize and smooth_spiralized_contours...

Triodes