Felipe Oliveira

To have light in led is necessary configure it to do. Read max30100 datasheet and you will understand better. Em sáb, 4 de mai de 2019 2:41 PM, celciusjj escreveu:...

Sorry for my delay and no problem for your english, I no speak english well yet, I speak portuguese... So... about change the resistor, wait to do it, this will...

**1- what scheme did you use to mount the circuit:** I use standard connection. At this time I´m not using Arduino, but NXP Freedom kl02 board. I only connect Vcc,...

uhnnnnnn... Basead in your tutorial, you will really need remove pull ups connecteds to SDA and SCL and use resistor to +5V to do it work in Arduino. At my...

What did you do? Change you pull ups ? Em seg, 6 de mai de 2019 10:11 PM, celciusjj escreveu: > Hello again, the led now is on, but in...

Verify your baud rate of serial. Em seg, 6 de mai de 2019 10:34 PM, Felipe Moura Oliveira < [email protected]> escreveu: > What did you do? > Change you pull...

You need put same value in serial monitor. Do you verify it? Em seg, 6 de mai de 2019 11:24 PM, celciusjj escreveu: > I have 115200, what value i...

You tried connecting just VCC, GND, SDA and SCL? I just use that pins. And... you put pull ups?

I believe that you can not shutdown max30100. This feature is present in max30102. About shutdown leds... u can set current to 0.0 mA (change register with address equal 0x09),...

This library no will work with MAX30100 because memory map of it is different. Looking for: Max30100 - >  To MAX30102, you have:  Max30102 have same memory map...