FabioMC

Yes. Have modified but no success. The output pins are limited. I found that one option is to use the Power_Off pin but than I will loose the configuration to...

I would like to try TX RX UART 3 since looks more simple. What are the pin codes for those? PB10 and PB11? Is that correct?

Ok. Tried UART 3. I used PB10 since its near the GND so an easier way to fit the connector. Everything is working properly. Thanks for your kind feedback.

 Here it goes

Not really. I am using MKS-TS35 which uses only EXP1 and EXP2. I may not be able to use the new MKS H43 though. So far everything is working fine.

It is a very simple configuration. Enabled NEOPIXEL_LED and put the PIN number in front of NEOPIXEL_PIN. You don't need to change any other file // Support for Adafruit NeoPixel...

His suggestion is to use the PIN PD8 into the E1 step motor jumpers. Please note that 5V and GND need to be connect to other place like the MT-DET2...

If I load this firmware sent by @acguardia to the wifi module, the MKS-UI will work normally or it just works with Marlin Color UI?

@trashypopashy. Updating a little my experience on that. I moved on and upload the WIFI firmware sent by @acguardia. The WIFI communicates by the WEB Interface with the printer and...

No. Just set the 2nd COM to 1 as you and upload the WIFI.bin into the MKS-WIFI hardware. I did not touch the Wifi options on Config_ADV (all disable). After...