Assisted setup with Corsair devices inconsistent detection.

[No-good-deed-goes-unpunished]

All of my computers run Corsair PSUs and coolers, hence why I'm posting here.

Updated to Fan Control 186 to resolve issue with an exception in assisted setup.

I have two PCs running MSI X299 XPower Gamin AC motherboards - LGA 2066. I cannot afford to replace these systems. All fans are plugged into the SYS_FAN headers, and NOT the EXS fan headers. I've had to connect a couple of fans with a splitter to avoid using the EXS headers as a post some time ago suggested these headers are not supported.

When I run assisted set up on either PC I never get the same results twice. Today, the only sensor detected was for my HX850i PSU. The cooler (PC1 - CW-9060044-WW; H115i Pro RGB XT), was not detected at all. Neither were any of my case fans. Not a single one.

PC2 - CW9060059-WW is reported as a separate issue.

I delete the entire fan control folder, including configurations and cache. Everything gone. re-extract the portable version and run assisted set up again. Different results again. 3 of 5 case fans and PSU, still no cooler.

There are 2 fans on the cooler, and 5 case fans (1,3,4,5,6).

Even after deleting all traces of Fan Control each time I reinstall it I can see the H115i cards. So at some point a version of the DLL detected the cooler. I can manually pair, but one cooler fan is showing as 0 RPM even though it is spinning quite fast and loud.

Is this simply because the X299 is not supported?

I'm sorry of this is in the wrong place. I don't know if this is an issue with Fan Control, or the Corsairlink plugin

CorsairLink.1.log log.txt