ERCF_v2 icon indicating copy to clipboard operation
ERCF_v2 copied to clipboard

Published 20 hours ago • verified publisher icon Enraged-Rabbit-Community

[Documentation] Missing instructions for Easy BRD install, and other boards

Open EllaFoxo opened this issue 1 year ago • 6 comments

Had to figure this out for myself. There's no CAD for Easy BRD either, so it wasn't immediately obvious where and how to mount the board. Would be good if there was a document on the Git repo at the very least, but ideally incorporated into the manual.

EllaFoxo avatar Dec 31 '23 02:12 EllaFoxo

This is a duplicate of https://github.com/Enraged-Rabbit-Community/ERCF_v2/issues/16

spikeygg avatar Dec 31 '23 15:12 spikeygg

This is a duplicate of #16

That's my own. And no, it's not a duplicate. Did you even read the two?

EllaFoxo avatar Jan 01 '24 22:01 EllaFoxo

@tinyfluffs could you share how you did it? I am currently stumbling over this as well^^"

sharpner avatar Jan 30 '24 16:01 sharpner

@tinyfluffs could you share how you did it? I am currently stumbling over this as well^^"

Sure! Here's some photos from my build log. Basically, two t-nuts for the mounting frame. Then it's M3 screws threaded into plastic for the MCU.

photo_2024-01-30_20-28-44 photo_2024-01-30_20-28-45 photo_2024-01-30_20-28-46

EllaFoxo avatar Jan 30 '24 19:01 EllaFoxo

awesome thanks so much - looks super clean :)

sharpner avatar Jan 31 '24 08:01 sharpner

awesome thanks so much - looks super clean :)

No problem! One thing I do recommend is running a separate 5V rail to your servo. The Easy Brd 5v rail is not powerful enough to handle ERCFv2, as it needs extra current. If you have a 5V PSU you can just run the single cable from there, provided the grounds are tied together with the 24V.

EllaFoxo avatar Feb 01 '24 00:02 EllaFoxo