ERCF_v2 icon indicating copy to clipboard operation
ERCF_v2 copied to clipboard

Published 20 hours ago • verified publisher icon Enraged-Rabbit-Community

Gneu42 Block End mod issue

Open Benoitone opened this issue 1 year ago • 3 comments

@gneu42 I think in your Filament_Block_End.stl from your Reinforced Block End Mod the two little conicals holes are missing? End_Bypass gneu

Benoitone avatar Dec 23 '23 15:12 Benoitone

You are right, they are missing, but I did not remove them. They were already missing on the part that I used as base for the modification. They must have been added later on to the V2 final block end. They are not needed on my setup, since the foot is not under them. Capture

gneu42 avatar Dec 23 '23 16:12 gneu42

You are right, they are missing, but I did not remove them. They were already missing on the part that I used as base for the modification. They must have been added later on to the V2 final block end. They are not needed on my setup, since the foot is not under them. Capture

Ok. it's the foot from the original SturdyBunny :)

Benoitone avatar Dec 23 '23 16:12 Benoitone

I added the 2 missing conicals holes, so it can be use with the official V2 foot.

gneu42 avatar Dec 24 '23 07:12 gneu42