AlphaX

i think this was solved

Does this work? Mitsubicha runs fine on sequential but have not tested individually wired wasted

What are the settings for your launch control?

tf, well I attached the log, and the pulse width basically changes tracking the VE table

How about "Symmetrical 3 tooth"? And, why can't this kind of setup be detected using "Custom toothed wheel" If there are no missing teeth, and ignition is not "single coil",...

can i have switchable Y axis on boost table yet

this pretty much is how it works

This can be closed as it is the same as 4b11 double rpm ticket

Sstill relevant

STILL RELEVANT (x) = hysterisis if hard cut is 240kpa, and (x) is 20, when the ECU sees 240kpa, fuel/ign will cut, and stay cut until 240-20=220kpa is reached