EdgeTX
Jumper t16 + Flysky digital hall gimbal issues with EdgeTX "Centurion" v2.10.0-RC3
Is there an existing issue for this problem?
- [X] I have searched the existing issues
What part of EdgeTX is the focus of this bug?
Transmitter firmware
Current Behavior
Flysky digital hall gimbal cannot work on T16，Unable to use even after recalibration.
Expected Behavior
I hope to use it normally and really want to experience the new features brought by 2.10
Steps To Reproduce
Upgrade to 2.10rc using Flysky digital hall gimbal Joint T16
Version
Other (Please specify below)
Transmitter
Jumper T16
Operating System (OS)
Windows
OS Version
No response
Anything else?
No response
Unable to use even after recalibration.
What does this mean? Do the gimbals not work at all? Intermittent response? Poor resolution?
https://github.com/EdgeTX/edgetx/assets/39640832/32ac9c87-d6ef-474b-bcfb-f120f2d26bb5
gimbals
Yes, the gimbals doesn't work at all
Unable to use even after recalibration.
What does this mean? Do the gimbals not work at all? Intermittent response? Poor resolution?
Yes, the gimbals doesn't work at all
I got exactly the same problem on my Jumper T16. I tried with 2.10.3. Going back to 2.9.X makes the gimbals work again. Calibration on 2.10 is impossible. According to discord support I also updated the bootloader to 2.10.3 by DFU flash. I also deleted the models and radio folders and rebooted the radio. Then it goes over storage prep and jumps immediately into calibration. No success either. Happy to help logging. I do not have HW debug capabilities.
