Eddiiie

I have 2 extruders and 4 fans. On my old RAMPS board I had this working. It looks like I can re-use some other pins that I won't use like...

I have 2 extruders. 1 fan on each extruder. My Marlin configuration_adv.h for auto temp says ``` #define E0_AUTO_FAN_PIN P0_00 #define E1_AUTO_FAN_PIN P0_01 #define EXTRUDER_AUTO_FAN_TEMPERATURE 50 ``` I use the...

Set your baud rate to 115200?

I did some poking around and found that the following pins have PWM - **Verified PWM works - Z-Stop P1_27 PWRDET P1_00 I2C_SCA1 P0_00 I2C_SCL1 P0_01 SPI P0_26 (top left)...

Fixed! Thanks!

I have this board (STM32G0B1RE). Is there anything I can do to help test m43 fix? :)

Hi @ellensp (and @thisiskeithb ) Not sure if I did this right, but I think so... because it compiles!! M43 would not compile before your patches. Here is what I...

Print job finished, firmware updated. Sent M43. It looks like it works. There are a couple of strange characters on the terminal window (using Octoprint) for some of the pins......

Same here. lol WTF

So basicly this board is useless (must use octoprint). I cannot get the stepper motors to move at all. There was the Rev A board problem too. Run away!!