Erdem U. Altinyurt

Well, at least you see some improvement but yeah it's weird situation. This tool is just for nuvoton N76E885AT20 MCUs that controls rgb led lights via i2c bus, at some...

That good news Dave! Indeed your hardware uses Asrock Polychrome RGB FW but compatible! :) Or you can try my updated search routine. I think all AsRock boards using 0x6a...

Hi Dave. Indeed your firmware version is 3.0. This tool just released for v1.10. I don't even test on v2.10. But It's good to hear that at this runs on...

Thanks @ozarchie . Indeed problem is; after years Espressif IDF looks like does not accept/support ledc output pin as i2s clk input pin, directly. You need to define another pin...

I look at C3 and... I don't say that it's not possible but... Not compatible with current code. Also there are some issues with C3's I2S DMA RX operation, located...

Not tested under mac. Normally, you should need to detected by pulseview if you correct baud rate for the device. Working O.K. under Linux. Will test on mac.

Hi, using latest code, there are no USE_SERIAL2_FOR OLS.... but just _DEBUG_MODE_ Debug mode use serial 2... I think, only you should do that use latest close and remove #define...

I found a problem, might be it's related with this. Espressif IDF changed and now we can't use LEDC output to I2S input from same pin, directly. Only solution that...