EMDM25

Results 22 comments of EMDM25

I been try to enable a dual z but i get this error at the time of compile the file.

![Annotation 2020-09-01 215457easy](https://user-images.githubusercontent.com/68138008/91923932-8b585a80-ec9f-11ea-83b7-cbd10c2da796.png)

I been try to enable a dual z but i get this error at the time of compile the file.

![Annotation 2020-09-01 215457advanced](https://user-images.githubusercontent.com/68138008/91923940-8e534b00-ec9f-11ea-853c-81bf5325186b.png)

I been try to enable a dual z but i get this error at the time of compile the file.

I have tried to send all the command for the bltouch and it didn't work

I been try to enable a dual z but i get this error at the time of compile the file.

Here is my Conf file if that can help you, is possible that I did something wrong [Configuration.zip](https://github.com/markniu/PandaPi/files/5160119/Configuration.zip)

I been try to enable a dual z but i get this error at the time of compile the file.

CONFIGURATION.H /** * Marlin 3D Printer Firmware * Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin] * * Based on Sprinter and grbl. * Copyright (c) 2011 Camiel Gubbels / Erik van der...

I been try to enable a dual z but i get this error at the time of compile the file.

CONFIGURATION_ADV /** * Marlin 3D Printer Firmware * Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin] * * Based on Sprinter and grbl. * Copyright (c) 2011 Camiel Gubbels / Erik van der...

I been try to enable a dual z but i get this error at the time of compile the file.

PINS_PANDA_PI #ifndef BOARD_NAME #define BOARD_NAME "PANDA,PI" #endif #define BOARD_INFO_NAME "PANDA,PI" // // Servos // #define SERVO0_PIN 255// 0xBE // #define X_MIN_PIN 1 #define X_MAX_PIN 1 #define Y_MIN_PIN 4 #define Y_MAX_PIN...

I been try to enable a dual z but i get this error at the time of compile the file.

Yes it does

I been try to enable a dual z but i get this error at the time of compile the file.

I check it a couple of time and tried the bltouch in another printer it did work

I been try to enable a dual z but i get this error at the time of compile the file.

Like that ![504185717](https://user-images.githubusercontent.com/68138008/91983355-8cb67100-ecf9-11ea-874c-7cf4a887dca7.jpg)