EBiCS_Firmware
EBiCS_Firmware copied to clipboard
EBiCS
Free FOC firmware for Lishui E-Bike-Controllers
Do I need to add 10k pullup resistor to 12FET controller for R_TEMP_PULLUP functionality? I have 10k NTC thermistor pulling down in the motor.
Hello, I have a SCO e-Trekking Premium (Danish brand) and It has a Shengyi CMT03 motor installed. I believe it has a LD-LS11-F controller in it, but I am not...
Hi, I'm wondering whether this controller firmware is applicable to Rad Power Bikes with the Lishui controller, and I'm wondering whether the original display would be supported. If not, would...
is it confirmed that das-kit ct5-i5 is an actual lishiu controller ? Also if we use custom firmware is there any compatible display? thank you
In case of 2.2 m of wheel circumference, single magnet in the spokes: ``` #define WHEEL_CIRCUMFERENCE 2200 #define PULSES_PER_REVOLUTION 1 ``` When the speed reaches 4r/s (4 * 2.2 *...
It seems like the macro `CAL_BAT_V` in generated `config.h` corresponding to the parameter "Battery Voltage" is only used for battery capacity level calculation for Bafang display module, it is likely...
Enables speed and temperature multiplexing on the same (usually white) wire. Works with 10k NTC thermistor with customizable Beta value. To retrofit into existing motor with speed sensor, connect NTC...