DrumClock

Hi, I think if they wanted to in BTT, it wouldn't be a problem for them. Unfortunately they don't want to ..... they won't even provide the original bootloader (...

Hi @GadgetAngel > I have created a PIN file showing these correction and a Color_PIN file also showing these corrections. They both can be found at my github page: https://github.com/GadgetAngel/GTR-V1.0-Stepper-Driver-Jumper-Configuration-Manual...

Hi @edriyin1 I removed the resistors R90-R95 redefined the TX / RX pin and I can use the EXP3 connector for BL-touch Info here : https://github.com/makerbase-mks/MKS-RUMBA32/issues/34 point 2 - UART...

Hi @mks-viva , @makerbase-mks first I loaded FW Marlin using STM32 BOOTLOADER and DFU mode without any problems. Now I wanted to upload a new FW but nothing is happening....

Hi, I tried another computer and it's the same. Everything indicates that after holding the BOOT button and plugging in the USB cable the board does not invoke the DFU...

Heureka! **the inability to start the DFU mode is caused by the connected EXP2, EXP1 connector with TFT35 E3 V1.0 display. If theEXP1 EXP2 diisconnects the DFU mod is activated.**

Hi, @PADYT0007 I don't use Merlin anymore, I switched to the better FW Klipper. So I can't for you do nothing.

> > Hi, @PADYT0007 I don't use Merlin anymore, I switched to the better FW Klipper. > > So I can't for you do nothing. > > Can I use...

does not support I2C, DSI or CSI ....they are beautiful E-Waste, nothing more....

> The product pages for the PI4B, Manta 4, and Manta 8 CLEARLY state the CSI & DSI ports aren't compatible with the CB1. I would say that's a definitive...