Alain Turbide

The 05 command differs as well. Mine has 8 data bytes while the older panels as seen in your dumps, show 4 bytes. My pleasure for the contribution. It was...

Another note. Module supervision is not required for the expander to function normally. In the emulation code, I added a config to control this. This makes it easier for testing...

Not a problem Nikhil, I'll hook up the modules and get some logs. That's one thing I have not tested much is the tamper since I wasnt planning on emulating...

My testing agrees with krikon on the 0x87 pgm outputs. ie pgm1-14. As far as the dscalarm.h decoding goes, I was more concerned with the pc5208 relay board channel decoding...

Examples. All are done by first pressing the tamper switch then release. These were all from a pc1832 ver 4.6 panel ``` PC5108 zone 9-16 40087.86:[MODULE] 5: 11111111 1 11111111...

Closed as code is obsoleted.

I use my own implentation of this library for my own projects as I had a few specific requirements not supported here.

I use chrome all the time and no issues. Try pressing F12 to open the debug console and then F5 to refresh the page with the keypad view. Error messages...

I have some examples here you can also look at. My code is written for the ESP8266/ESP32 platform. Even though it is technically setup for HomeAssistant, the vista library can...

If your motion sensors are assigned to zones, you would need to setup some zone sensors in your config yaml for them to be reported normally. You would see FAULT...