Dmytro

The same issue on Orange PI Lite (H3 Allwinner) with 1080p@60 screen

@hamedmalekii Hello, Are you use this initial sequence: ``` oled.begin(132, 64, sizeof(tiny4koled_init_132x64), tiny4koled_init_132x64); oled.clear(); oled.on(); oled.init(); ``` ? Note that the width here is 132 instead of 128...

@hamedmalekii The first thing I advise you to do is to check the display that it works at all - on Arduino with some library and take an example of...

Hello. Yes, you may be right. But I made these settings based on the video from YouTube example: https://www.youtube.com/watch?v=hFpXfSnDNSY And as you can see, those settings fit for my display...

The same issue.

For me solved issue with alternative firmware: https://github-com.translate.goog/pvvx/THB2?_x_tr_sl=ru&_x_tr_tl=en

@Xitee1 Polling the readings every so often serves to minimize the delay of e.g. boiler or floor heating operation (if these heaters depend on the sensor). For this purpose the...

Same issue: Home Assistant: why is Power **Detected** status? On ATC_v46.bin was status **Clear**.  Get sensor Settings in TelinkMiFlasher.html report zeros:  (If I Set Default - it was...

On Debian(Armbian tested) you can bypass the option to write the BlueZ cache to disk in two ways: **First one:** recompile BlueZ with the modified STORAGEDIR option in a folder...

My Orange Pi (Armbian **only SD-card**) + Home assistant were disabled logging to the memory card, the memory card by the way is used Smasung High Endurance. In Home assistant...