M00 stops program but can never be resumed

[Gpopman]

Versions

• Candle version: [e.g.: 1.2.13b, 1.2.14b]
• Firmware version: [1.1f]

PC info

• OS: Windows 10 Pro 64
• OpenGL version: ??

Describe the bug If I place an M00 command in my code to stop the program so I can change the drill bit sizes for PCB hole drilling, the program never resumes after I hit the PAUSE button. This does work in Candle version 1.1.7. I've written code to follow the bit change to re-probe the Z-axis zero, but it only gets that far in version 1.1.7. I tried 1.2.13b and 1.2.14b because I thought it allowed for tool change, but the program hangs after encountering M00. Reset if the only way out at this point.

To Reproduce Steps to reproduce the behavior:

1. SEND program file.
2. Program stops at M00 as expected.
3. I change drill bit.
4. Hit PAUSE to continue program to do my code for Z-Probe. It would be nice if the Z-Probe button was active mid program run at this point of pause. (Is it possible to add this feature ?).

Expected behavior I expected the program to pause at command M00, which it does, then hitting the PAUSE button should take it out of hold mode and resume my code, but PAUSE is greyed out. This works in version 1.1.7.

Screenshots

Example files Add G-code files that cause problems.

Additional context Add any other context about the problem here.

[pad73]

Try push the HOLD button, beside the homing button in Control panel