Blobifier
Blobifier copied to clipboard
Dendrowen
Sketch plane was lost here:  Likely this was done when the work was done to create different bed widths.
It appears the slot support is a fused to the base in Base+1.stl. The others all seem ok, but Base+1 appears fused and even looking at the unsliced STL in...
It looks like this line makes servo to turn in neutral (middle) position: SET_SERVO SERVO=blobifier WIDTH=0 I try almo any other settings - no change. Also I try different servos...
Whilst testing the Blobifier I found that with a beacon, it does not account for the brush height when moving from z homing position to the brush start position causing...
Missing support: Base+3.stl and Base+4.stl 
Is it possible to run Blobifier without the rest like the Purge Bucket getting shaken, the activation of a Servo, etc...? If so, how could one accomplish this?
Hi friend, I have a sovol sv08 with ercf, could blobifier be adapted for this machine?
When the bucker gets full the toolhead parks without retracting the filament. Then the print is paused, leaving the filament to cook and clog. Filament ahould get cut or tip...
