Arduino Ethernet shield 2

[Kaliph]

I bought an Arduino Mega with a Motorshield and an Ethernet shield 2. Over usb it works perfectly with the controller, but I can not get the Ethernet shield 2 to run with the DCC Software. Is it correct that I have to select COMM_INTERFACE 1 ??? This is how my configuration file looks like. The Board does not reply on a ping command. So I assume it does not work properly. Any kind of help would be appreciated. Thankyou

`///////////////////////////////////////////////////////////////////////////////////// // // DEFINE MOTOR_SHIELD_TYPE ACCORDING TO THE FOLLOWING TABLE: // // 0 = ARDUINO MOTOR SHIELD (MAX 18V/2A PER CHANNEL) // 1 = POLOLU MC33926 MOTOR SHIELD (MAX 28V/3A PER CHANNEL)

#define MOTOR_SHIELD_TYPE 0

///////////////////////////////////////////////////////////////////////////////////// // // DEFINE NUMBER OF MAIN TRACK REGISTER

#define MAX_MAIN_REGISTERS 12

///////////////////////////////////////////////////////////////////////////////////// // // DEFINE COMMUNICATIONS INTERFACE // // 0 = Built-in Serial Port // 1 = Arduino.cc Ethernet/SD-Card Shield // 2 = Arduino.org Ethernet/SD-Card Shield // 3 = Seeed Studio Ethernet/SD-Card Shield W5200

#define COMM_INTERFACE 1

///////////////////////////////////////////////////////////////////////////////////// // // DEFINE STATIC IP ADDRESS OR COMMENT OUT TO USE DHCP //

#define IP_ADDRESS { 192, 168, 178, 200 }

///////////////////////////////////////////////////////////////////////////////////// // // DEFINE PORT TO USE FOR ETHERNET COMMUNICATIONS INTERFACE //

#define ETHERNET_PORT 2560

///////////////////////////////////////////////////////////////////////////////////// // // DEFINE MAC ADDRESS ARRAY FOR ETHERNET COMMUNICATIONS INTERFACE //

#define MAC_ADDRESS { 0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xEF }

/////////////////////////////////////////////////////////////////////////////////////`

[chrisridd]

Have you set your shield's MAC_ADDRESS properly? It might be written on a sticker on the shield. DE:AD:BE:EF:FE:FE is a sort of (joke) placeholder address.

Have you tested your Ethernet shield without DCC++ to make sure it works? There should be some examples in the IDE.