Ian Veldman

It's a bit of work,  but let me see if I can get my Robin wired up and test it. Not sure what the time line will be.Sent from my...

Hi Elmo40 I did a basic setup and it tested fine. I could control the fan from Repetier Host Manual Control tab and sending GCode M106. M!07 turned it off....

Yip, so far I'm less impressed with mine as well. I had my MKS Robin2 go coco on me. I reloaded the firmware. That worked for me. I can't get...

Thanks 3Dangel For the most part my Robin2 is working. I have a 400 mm x 400 mm bed, so bed leveling is essential. The controller does everything, performs the...

Jan H Thank you for sharing your information, much appreciated I might miss it, but did you solve your issue with "Homeing"? I'm building a coreXY printer. Due to inexperience,...

Thank you very much Jan H. I'm waiting for my Robin2 controller..It's in the mail. I will put it to the test when I receive it, probably only in 4...

Hi Jan I'm making good progress with my CoreXY printer. The Robin2 seems to be working well. I have some difficulty setting and configuring the Z-height. My bigger problem seems...

Tothyr I had the same problem, but solved it. 1) You do not change any configuration setting(s) in Configuration.h to Configuration-adv.h that relates to screen/lcd/touch. In my case I had...

Bhusum I have the SKR pro. SKR V1.3 and SKR Pro configurations are different. I have problems with mt TFT35 V2 as well. I did the hex upgrade. After uploading...

Bhusum I was busy writing you a long explanation of my experience when I decided to read your post again. It provided me with a clue as to what I...