CueDev
CueDev
> Hi, > Please check the instructions: for 6.0 the version of binutils is 2.22. > Also, it should work just fine on CentOs 7.x, provided you have the appropriate...
> Are you using the build script (build-r8152-2.06.0_u60.sh)? The following line will be set at the top: > LD=/build/toolchain/lin64/binutils-2.22/bin/x86_64-linux-ld > So, if you are using the script and binutils-2.22 is...
Hi, I have also downloaded your compiled vib pacckage from https://bintray.com/gomesjj/VIBs/r8152_esxi65_vib/_latestVersion But this also generates an error when installing, steps i performed are: 1. Put server in maintenance mode 2....
> Hi, > Firstly, you don't need to put the server in maintenance mode, nor do you need the "-f" flag. However, you must provide the full path to the...
Hi, I fixed the installation issues of the driver. Steps taken 1. Disable Secure Boot 2. Change software acceptance level to CommunitySupported 3. Installed the driver 4. Rebooted server But...
> Hi, > You need to disable the vmkusb native driver with the following command, then reboot: > esxcfg-module -d vmkusb Hi, Tried both - esxcfg-module -d vmkusb (then reboot)...
Hi, This is the result I get `[root@localhost:~] vmkload_mod -l | egrep "r8152|usb" vmkusb_nic_fling 3 800` `[root@localhost:~] lusb -sh: lusb: not found` `[root@localhost:~] lsusb Bus 001 Device 003: ID 045e:07c6...
Hi, It is getting a little bit ridiculous to get an (supported) USB NIC working. I tried the following but no NIC is shown. Completely reinstalled the hypervisor (nothing running...
> Hi, > Your email listing the output of vmload_mod /-l shows the vmkusb_usb_fling module loaded; that’s effectively the vmkusb module plus the FreeBSD ax8179 and usb_cdc modules loaded. You...
> Hi, > Your email listing the output of vmload_mod /-l shows the vmkusb_usb_fling module loaded; that’s effectively the vmkusb module plus the FreeBSD ax8179 and usb_cdc modules loaded. You...