Chucksbp

Being that your getting an RPM reading on your display it sounds as though you are wired properly to that point. when you turn on the power to the motor...

Unfortunately I'm far from an expert, but I do have a bit of electronic background, I would say you are ok with the motor to control wiring being that the...

I understand what you are saying, to test anything above continuity and voltage you need more sophisticated tools and above all electronic knowledge. I ran into this with the encoder...

I was thinking some more about your problem, I know you said the display shows RPM, does it also show the 4 LED s on and display the cut value??...

I am so glad you got the problem solved! the ELS is such a great system when working! it really makes a great improvement over change gears. My installation is...

Why don't you email me rather taking up room on this site, I actually extended my lead screw, very easy to do. I can explain in detail with pictures. Send...

I decided to post it here, if they don't approve they can remove it, possibly it will help someone else. My lead screw is 1/2 inch 16 the end where...

If you are running a 3 to 1 ratio at your servo motor, your stepper micro steps should be set at 3 the stepper resolution should be set to what...

Im not an expert but from my understanding the end result of speed is resolution times micro steps. I don't know what the limit is in the software. But your...

Your welcome!! i'm glad that combination worked for you! I had no idea that the ELS soft ware was limited to 2,000. But the work around did the trick. The...