Chucksbp

From what i read you are saying the lathe has an internal ratio of 13 to 1 you are adding a second 3 to 1 with your belt that would...

Lets start from the basics. All the external gears are gone. First is your encoder running at 1to1??? If so that is good! Next if you turn your 60 tooth...

As far as the configuration is concerned, you set the steps to what the motor is set at if you have the motor resolution set at 1,000 on the motor...

I believe you are going to have to pick which function to use. you will probably have to set every thing up to your lead screw function in order to...

No you were correct with 3 in the configuration file with your 3 to 1 ratio as long as the lead screw was turning at a 1to1 ratio from there,...

My lathe as simple i only have a lead screw used for turning and threading. My pulley goes right on the end of the lead screw no reduction invo ...

Yes James is very vague in his statement. He nor I have your type of lathe so i guess its experimentation. I hope it works for you but if it...

The easy way to tell if things are correct is to set your ELS to metric thread in your case and set the thread to 3mm mark your chuck and...

you are welcome, i hope you get it working well. Its truly a great device when its working as it should. If yo dont have a 1 to 1 in...

> Sorry, just attaching the pdf to the email didn't work, attaching here again.. [Clough42 Electronic Leadscrew.pdf](https://github.com/clough42/electronic-leadscrew/files/8134951/Clough42.Electronic.Leadscrew.pdf) . Nice right up and very nice work!!!