Chucksbp

Clough 42 is developing a new display board because of failures on the boards. that being said in the interim I would order a couple boards fro ebay or Amazon...

im glad you have it working! If you dont want to disturb the display by changing to the angle pins on the other side of the board., I just bent...

My Display cable is close to 2 meters (6ft) in length and I have never had any issue with the display other than the first one didnt work at all....

By the way, that's a very nice installation and a great video! And as always a great explanation by James!

There is a lengthy discussion of this problem below, discussion 197. Many of us have had this problem. Did it work and then stop or did it never work. If...

Did you re configure, re flash the TI board?? you just cant move to the other input. On code composer right below the resolution it says #define encoder_use_equep1 below it...

I am sure the board could be diagnosed but I doubt that it could be done with normal DIY tools. Plus you would need some schematics with voltages and possibly...

There was just another gentlemen above that closed his question he also did all the testing etc. turned out to be a failed encoder. This seems to be a much...

Honestly, i understand, I was lucky I guess my ELS worked for an hour or two then suddenly stopped. That was about a year ago and Launch boards were very...

i cant confirm the reading on the pins, but i can only say it doesn't make sense that there would be voltage at the other pins. you may want to...