Chucksbp

That's what my settings are. did you check your motor dip switches to be sure they are set for 1,000??? my motor was not set for 1,000 when i got...

What value did you originally have in steps and micro steps

for the first question the stepper resolution has to stay the same, it has to be what the motor dip switches are set to. so if you have the motor...

You actually need to go twice as fast another words a 1.5 to 1 ratio. from my understanding fractions aren't allowed, can you try leaving the 3 microsteps and changing...

> That works a treat. Need to tweak the settings a little but now have way better speeds. Thank you. Can you please explain exactly what you put where in...

Thanks so much!! i have a friend that will need to do that very thing soon, i'm sure we would have run into problems.

If you look below in older issues we had some failures with the import encoders taking out the input of the Launch board. there is a better enoder on Amazon...

Your welcome! I dont think any eletrical noise would be an issue unless in direct contact with the board or grounds. Although there is always a slight chance of statuic...

My guess is that the cable box is going crazy from feedback on the AC line not from EMS. And again it isn't ruining the cable box just disturbing it....

If the display is from 2019 i would highly suspect the display board. I did mine in early 2020 and went through several boards before i got a good one....