Chucksbp

Ryan, I am having the same issue. my ELS was working fine and just stopped. Its a new build actually just had it up and operating a few days. I'm...

Ryan, I am sure these are Chinese knock offs. My installation is on an Atlas 618, so the encoder has never seen 1,000 RPM. When mine quit I was just...

Just a hunch, but the more expensive encoders seem to have a yellow or orange stripe on the label of the encoder?? James had the link to eBay as far...

That's good to know. Did you happen to get yours operating yet??? I should have a new encoder tomorrow from Amazon if delivery is on time. I'm hoping it Fixes...

You have to go into the configuration H file and change the pin designation and re flash the board for the second set of pins to work. If that doesn't...

I absolutely agree, I wouldn't take a chance on re flashing nor would i take a chance of using the old encoder. the old encoder may have ruined a resistor...

I have installed "Tunes" on trucks I have owned. I use a stand alone device to install the Tune but its basically the same thing but takes much much longer...

My encoder is driven from my spindle with a GT2 5mm belt using two 60 tooth pulleys. Much like James did on the original build. I mounted the encoder on...

That's a very nice installation, very neat and tidy! When you say your feed is too fast, are you meaning your RPM reading is too fast or your Lead screw...

That's a great set up for the encoder, you have a lot of room to work with there. I am very cramped for space on a 6 inch lathe plus...