Danol (Daniel Čejchan) comments

Results 271 comments of


                                            Danol (Daniel Čejchan)

Use "test suite" rather than "test case" in error about mixing TEST and TEST_F

Internal ticket: BFW-7075

Use "test suite" rather than "test case" in error about mixing TEST and TEST_F

Could you guys please test the following? * Have the "log to txt" in Settings → System enabled during the failing bed leveling, send the log file here * Check...

[BFW-6419] To long filenames gives a 415 "Unsupported Media Type" "Not a gcode" error

Internal ticket: BFW-6419

[BFW-6795] Impossible Print? Repeated Print Failures - Arctos Robot X Pulley

This is likely a firmware bug, not a slicer bug. There is an issue for this in the firmware repository: https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/4465. Internal ticket: BFW-6795

[BFW-6795] Impossible Print? Repeated Print Failures - Arctos Robot X Pulley

I was merely trying to move the discussion to the firmware github repository. Here we are in the Slicer repository, which is maintained by the slicer guys, and us FW...

[BFW-6795] Impossible Print? Repeated Print Failures - Arctos Robot X Pulley

I'm trying to arrange a transfer of this issue to our repo.

[BFW-6795] Impossible Print? Repeated Print Failures - Arctos Robot X Pulley

@Luke2791 could you please also attach the exact gcode you used?

[BFW-6795] Impossible Print? Repeated Print Failures - Arctos Robot X Pulley

We were testing a bunch of specific prints people reported as problematic, not sure if this was one of them.

[BFW-6795] Impossible Print? Repeated Print Failures - Arctos Robot X Pulley

All right, I will run the print for you. I will also try to ask the testing if they remember whether they run this print.

[BFW-6795] Impossible Print? Repeated Print Failures - Arctos Robot X Pulley

Okay, the testing said that this gcode was not in the set. So I can only offer you testing it myself - running the print now, I will report tomorrow...