BruceDevices
ir problem
Describe the bug:
ir config not selecting Steps To Reproduce:
- Device used: M5 STICKC PLUS 2
Actual behavior: IR config not working: tx and rx dont selecting
have you tried using the default config for TX , also do you use external IR receiver ?
Describe the bug:
ir config not selecting Steps To Reproduce:
- Device used: M5 STICKC PLUS 2
Actual behavior: IR config not working: tx and rx dont selecting
are you connecting it right ? do you use g26 for receiver ?
I have 2 modules- tx and rx. Tx is working diy
Before i dont have that problem but today this probllem is started
what version are you using ?
Config is " not saving selection" only on rx, in tx config is saving but rx not saving
Not working, not selecting, when select rx, that selecting m5 ir mod
I think TX should be g26 , if you have the same module as the one on the picture , and m5 ir mod is selected as default i think
If you can, fix this bug, and set g26 for rx default, but that can change.
This is the story: yesterday afternoon I was copying ults with this rx module, last night it stopped reading remotes and didn't save the module data to which pin it was connected, everything was saved on the tx
This is the story: yesterday afternoon I was copying ults with this rx module, last night it stopped reading remotes and didn't save the module data to which pin it was connected, everything was saved on the tx
Was it connected without removing ? Like did you left it on connected for hours ? Maybe if we make the default receiver pin to g26 ? I will try to pull fix later today if i can , tho i cant reproduce for some reason
no, when i turned off stickc i disconected module, but when i wanned to read signals then i conected module and turned on stickc. then it works, but today thats didnt work
i changed config then tryed read signal but that no read then i see config and there is m5 ir mod