Problem Using WOR-Flasher

[SeaDog58]

Setup:

• Which version of Windows you chose: Windows Pro 11
• Raspberry Pi model: 5
• Name of SD card you tried to flash (some are too slow or too small): Using 500gb SSD connected to USB
• What day you first downloaded wor-flasher: Updated 22 May 2024
• What linux operating system you are using to run wor-flasher on. (Raspberry Pi OS, Twister OS, Debian, etc): Raspberry PI OS

Procedure:

Latest attempt to Flash Windows Pro 11 to a Raspberry Pi 5 using WoR-Flasher • Steps completed without error until “Downloading Windows ESD Image”. • Then errors in downloading numerous CUIDs. Error code 8. • Continued to download 4.8gb of data. • Download verified. • Extracted image.esd to /home/John/wor-flasher-files/winfiles_22631.2861_en_us • Preparations completed with GDK error which I understand is not critical. • I re-booted Raspbian OS after changing the boot order to start with NVMe. • In “Windows on Raspberry Pre-installation Environment”. • Displayed “Preparing Disk”. o Western Digital 1TB SN750 NVMe Internal Gaming SSD Solid State Drive - Gen3 PCIe, M.2 2280, 3D NAND, Up to 3,470 MB/s - WDS100T3X0C o It is in an external enclosure with a USB 3 cable. o The drive in this enclosure worked fine on a PC running Windows Pro 11. o After about 12 hours, there was no additional activity. • I moved the NVMe drive to a PC running Windows Pro 11 and used Disk Management to explore the drive. o There were 3 partitions – 953mb FAT32, 16.76gb exFAT, 913.38gb not formatted. o In the exFAT partition there is an install.wim file (5.1 gb) which apparently was never executed. • I have attached the Log file from the Pre-installation Environment. • Is there any way to use install.wim while drive is connected to PC? Any help would be appreciated. WoR-PE.log