BotoX

getSettings() writes the result into g_Settings variable And if there is no response/error then the communication failed.

The cells are fine, a little expensive but good performance. Nkon is a reputable source. But I don't understand why you don't just buy 48 cells (could use cheaper ones...

After doing getSettings just write g_Settings in the python console lol. That'll print whatever it received from the BMS

I have seen BMS which crashed when the scooter was driven hard. Flipping over the BMS or routing the cables different has fixed the issue for some. In principle the...

I've heard of the pro motor causing lots of back emf and resetting a BMS which works fine on the normal motor.

Seems like the serial UART connection is bad. It has no error correction or even detection. So communication errors will cause this behavior.

The firmware doesn't care how many cells your battery has. The TI BQ76940 chip can be reconfigured according to datasheet: https://cloud.botox.bz/s/JZD5gyQABipz2jg The original BMS app will not work, you're changing...

The BMS only has two connectors for the thermistors. The first thermistor pin is also the boot pin, so it requires special care, gotta try if you can make it...

BMS Password error is when cell voltage difference is >100mV. Wait for the BMS to balance the cells

Well in debug_print there are 13 cells, try m365 battery maybe? I only tried m365 tools with 12S