Blimpyway

First, if avrdude can flash the uC using ftdi adapter then is not a problem with recognising the avr's device signature and is a communication and/or synchronisation problem. There is...

I tested esp-link flashing of 16Mhz crystal pro mini clones with registers configured to run at 8MHz internal oscillator. I needed the lower frequency for 3.3V operation but crystal 8Mhz...

Aand one last thing I had to do to prevent esp-link interfering my pc based program talking with arduino is I had to disable esp-link's debugging messages. But if they...

I'd say this is an exceptionally realistic pattern. Real world patterns are seldom perfectly matched.

This is impressive, it looks more like active position holding than just a brake.

You mean [this?](https://github.com/byDagor/Dagor-Brushless-Controller/tree/master/Firmware/a_DA024F011)

The class is so simple that I think you can save all __init__ parameters including the self._w, self_beta and self._bias which are easy to serialize numpy arrays. Furthermore, you can...

Assuming your dataset have an x_train, y_train, x_test, y_test did you tried to simply use y_xxxx sets themselves. Just looking at mnist example 1. Normalise both X-s and Y-s within...

The same problem I had with Pi Zero, buster, and an edimax wifi-dongle. So none of these differences seem to matter. I tried to reduce resolution and framerate in pikrellcam.conf,...

I recall talks on arduino forum where people tested arduino's eeprom failing at up to 1M write cycles. The specs is 100k cycles. So.. I wouldn't worry too much. If...