BaltasarParreira

@MaximumSU I just finish test all DPs that have raw value and the only one that works is the 108 that I already have 2 setup, all the others are...

@MaximumSU No, still no go. I put all DPs that are not working on the reset but none of those are working.  Should I put on the manual DPs...

@MaximumSU Yeahh is not your software as the any other tuya soft I get the same problem, but it's strange the 108 working ok and all the others not, anyway...

Update: Just compile today the current Marlin 2.0 Bugfix Branch and the reboots disappear and it's stable. Now the problem is printing from Cura using the MKS plugin the printer...

I see, but on latest Marlin 2.0 Bugfix Branch this doesn't happened however with this I can't print anything since the printer moves like crazy all around on the X,Y...

So nobody wants to help solving this? I started investigating the source code looking for problems and a way of improvement. I already found some code typos and committed them,...

@chshkhr Yes the problems of rebooting and file transfers not reaching the end and so on are only on the merged version with Marlin 2.0. All the previews versions are...

@MKS-Sean The version I'm using is the one from the source here, I just clone and compile it last week. Do you want the compiled file is that it?

Just an update. Since there was new updates to the source I just did a git pull and compiled and install new firmware to check. Reboots once in a while...

Hummm, I didn't remember doing that test, I can test here to see if I get the same behavior. Anyway If we have MKS WIFI module is for using it...