SAMD21-M0-Mini
SAMD21-M0-Mini copied to clipboard
BLavery
Use for the Jlink
Hi, Thanks for your jobs. Its so usefull. I bought a jlink (chinesse) loader with the idea that I needed it to load a bootloader. From what I see, it is not necessary for anything. What can I use it for? Thanks again
Hello David, I bought a Jlink also. And I also have not used it & not needed it. It's lucky the Chinese versions don't cost too much!
I got as far as tracking down a miniature connector for those half-pitch pins. But then I never needed it.
Which of course is a different story from the STM devices, where using a STlink was pretty much a necessity.
Brian
On Tue, 12 Mar 2019 at 06:08, David Matias [email protected] wrote:
Hi, Thanks for your jobs. Its so usefull. I bought a jlink (chinesse) loader with the idea that I needed it to load a bootloader. From what I see, it is not necessary for anything. What can I use it for? Thanks again
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/BLavery/SAMD21-M0-Mini/issues/1, or mute the thread https://github.com/notifications/unsubscribe-auth/AIYX1boegVcMpyej4s1OLy1y8MNTCv-dks5vVreagaJpZM4bpdP2 .
I bought some of these boards from Robotdyn recently and found that I could use PlatformIO to program them if I set the board type to mzeroproUSB. Then Platformio used the stk500 upload by default and it worked perfectly.
