ATARAXIA MECHANICA

Yep, printing inner features slower feels weird but it makes sense when trying to make outer surface more consistent. Can't wait to try this. MSVC doesn't report build progress which...

I don't think it's working for me. On some layers, travel speed is applied to the outer wall while on some it's 10mm/s.  

This is the same model, in 2.0. 

Weird. Looks like if dropping the inner lines' speed doesn't slow it down enough, it immediately sets the outer wall's speed to a very low value instead of gradually slowing...

Yeah, even with classic mode it's acting weird. Currently thinking about what to print that has no overhangs and is small enough that the artifacts due to inconsistent outer wall...

Currently does not seem to be working. Can't wait for this to be a thing.

No idea why nobody came up with this idea till now, and why I didn't come up with this till I modded my 3d printer to print so fast that...

Found one case where this would be extremely useful. When printing with "infill combination" on, the layers with infill would take significantly more time than non-infill layers, causing uneven outer...

In this case, the outer wall in 2.0.0 would slow down just enough to hit the VFA speed of my printer causing resonance, while with no outer wall slowdown POC,...

But it slows down further than no narrow infill detection :( 50% speed and 100% fan should make the overhang in the image printable. Limited internal bridge filtering also causes...