AstroBox

AstroBox copied to clipboard

Remote ON/OFF switch of the printer

46

I'm using my raspberry pi, and I came with idea to add a button to web interface to turn off your printer after finish print or printer lights during print...

havanakuba

AP does not respect DNS settings provided by DHCP

1

AP should use the DNS settings configured from DHCP. Ideally, NTP as well, but that is more of a wish than is likely possible.

mrjester888

Need to be able to configure the IP address (IPv4, IPv6), DNS and NTP servers from the WebUI. Pretty straight forward request.

mrjester888

Bumps [pyyaml](https://github.com/yaml/pyyaml) from 3.11 to 5.4. Changelog Sourced from pyyaml's changelog. 5.4 (2021-01-19) yaml/pyyaml#407 -- Build modernization, remove distutils, fix metadata, build wheels, CI to GHA yaml/pyyaml#472 -- Fix for...

dependabot[bot]

Study using M73 for time estimates

1

A feature that I found very useful in OctoPrint was the ability to override the print time remaining if the GCODE had M73 print times embedded in it from the...

CoDanny

Lock focus on camera ( when supported )

1

https://forum.astroprint.com/t/focus-lock-on-logitech-c920/2083

CoDanny

CoDanny

Temperature presets should be sent to the cloud and displayed in the user interface.

Alfonsopl

The user should be able to define a position in the bed where the nozzle should move to before taking a photo for the timelapse.

CoDanny

Filament sensor

4

Can you guys add a filament sensor. I am thinking the main idea would be that the filament would run over a [Micro Switch ](https://www.adafruit.com/products/819) and close the circuit when...

Austinthemighty