Stepper stutters while doing the speed test

[fabiandj64]

When I use the macro for Klipper to perform the speed test my x axes runs all the way to the right "crashing" in the right "endstop" and then starts stuttering while waiting for the hotbed to run towards the front. After the speed test the steps are off by more than 10k bc of the stutter. I dont know how to fix this :/ I looked through the macro Code but could not figure out why it is doing this. Using an Sovol SV06.

[AndrewEllis93]

@fabiandj64 Try the updated macro. Wondering if you have the same issue as #66