Error in CANCEL_PRINT Macro

[dutchronnie]

[gcode_macro CANCEL_PRINT] rename_existing: BASE_CANCEL_PRINT gcode: SET_IDLE_TIMEOUT TIMEOUT={printer.configfile.settings.idle_timeout.timeout} ; set timeout back to configured value CLEAR_PAUSE SDCARD_RESET_FILE PRINT_END BASE_CANCEL_PRINT

on the bottom of the page https://ellis3dp.com/Print-Tuning-Guide/articles/useful_macros/pause_resume_filament.html#example-filament-sensor-config

There is the following text:

Then:

Put SET_FILAMENT_SENSOR SENSOR=filament_sensor ENABLE=1 in your PRINT_START/resume macros. Put SET_FILAMENT_SENSOR SENSOR=filament_sensor ENABLE=0 in your PRINT_END/pause/cancel macros. The above pause/resume/cancel macros have this already. Just update the sensor name.

But this is not Right: SET_FILAMENT_SENSOR SENSOR=filament_sensor ENABLE=0 is not in the CANCEL_PRINT macro, I have spent a lot of time to figure this out, because i assumed that this rule was already in the Macro

Can you modify the page? so others will benefit this.

This is only a comment, i Love your pages.