AlexVercammen

Trying to install using HACS, but Emporia_Vue is not showing up in the list whilst Emporia_Vue folder exists in the Custom_Components folder. So I am assuming the integration is failing....

I've figured it out. The entry is blank and @ the top of the list of integrations. Once clicked, a few seconds later 2 blank fields come up. 1st entry...

+1. A work around is to change the color assignment then revert to default if you want. In my case, "Change Line" has been set to bright yellow so the...

Same here after updating to 2022.9 In my case the integration is working. I can test the service: ``` service: notify.pushover data: message: Alex S10 & S8 title: PUSHOVER target:...

Issue is still ongoing after updating to 2022.9.5. Sending using service: `notify.pushover` works Sending using group: `notify.sms_alex` fails

I will second this request. Rename current "Temperature" to "Hot End Temp." and add "Bed Temp. Offset". Lovely request.

I think for each point. And if 1 of them exceeds the threshold prompt to Continue or Cancel. But the variance could work as well. Also, is 1 value for...

Do you think you can fix as well this issue of not rounding to 3 decimal digits for the variation calculation. 

Sorry about that. Thank you for entering it as an Enhancement. Secondly, any update on this enhancement. I know there was a major release which may have impeded your progress.

Cool, I'll try setup to a 12hour ETA since I would prefer a estimated time. The issue is when you have more than 1 filament change as the 1st change...