Miniscope-v4
Miniscope-v4 copied to clipboard
Aharoni-Lab
All things Miniscope v4
would love if the miniscope brightness could go below 1. I tried setting it to 0.5 in the config but unsure it actually worked. (yes gain is already down... I...
_This is intended to be more of a discussion and spot to organize and document ideas, as the google discussion is a bit dated and long._ **Image striping during acquisition**...
Hi,there. Thank you very much for the open source material,these are very good projects. We found a small problem of the miniscope. The setting parameters remain the same, but with...
Suggestion for improvement: The [DAQ Hardware](https://github.com/Aharoni-Lab/Miniscope-v4/wiki/DAQ-Hardware#power-jumper) wiki page says "Voltage supplied over the DC jack should be between 5V and 12V". This might be misleading for users that are unfamiliar...
Following up to https://github.com/Aharoni-Lab/Miniscope-v4/issues/32, I have made the technical conversion of the project to KiCad V6. What has been done: - The .gitignore file has been modified to exclude the...
**Describe the bug** I have found init for pin for signal Trigger0 `#define TRIGGER0_PIN PC2 ` is [here](https://github.com/Aharoni-Lab/Miniscope-v4/blob/81de4bb894e4debfcc07da5a57b8a0a9bf0b377b/Miniscope-v4-MCU-Firmware/Atmel/Miniscope-v4-MCU/Miniscope-v4-MCU/definitions.h) but this macro definition TRIGGER0_PIN is doesn't use in the any files...
