Torx12

Same issue here, with a large number of Parasoll sensors and a mix of Ikea Ladda and another brand rechargeables. The sensors connect fine, and they work fine for a...

Dongle-E as well myself, various versions of the NCP firmware. I gave up for now, unless someone has some ideas for troubleshooting.

@meiser79 I am facing the same issue on ember and on ezsp (both NCP). Is there a way to enable debug logging for one specific device? I went through the...

> * Does the same problem occur with the ember adapter? (not ezsp) Yes. Tested with both EZSP and Ember on 7.4.2.0 (and a couple of prior versions on EZSP),...

Any suggestion regarding targeted logging, @Koenkk ? Setting a global debug and then excluding devices one by one isn't very effective in my case, as I have a lot of...

> > • 3 IKEA Parasoll Sensors running • Zigbee2Mqtt with Sonoff P • First failure: 4-8 weeks? (most active sensor) • Reinserting the same battery did not work -...

Here's the funny behaviour I noticed for Sensor C mentioned above, while pulling the states for this. When checking first in Z2M (State tab), it looked like this: ``` {...

OK a bit more info. I decided to watch the other sensor that was still working (Sensor D), and it now behaves the same as Sensor C. The "last seen"...

Further experimentation - Sensor A was offline for several hours, LED blinking when door/window was opened/closed, but no updates at all in Z2M (neither contact, neither last_seen, marked as "offline"...

@Koenkk gladly. Is there a way to enable debug logging for only one / a few devices? I have tens of Zigbee devices (most of them working fine) and enabling...