Question: Can this be used reasonably for making custom non-split boards?

[KyleStiers]

Hello, I'm interested in using this to make a more standard layout (but still custom) board. I managed to get it installed and to render the correct layout as well as to remove the tent, as it's not a split board, but I can't figure out how to fine-tune the things you put in the design document. I'd like to add the MC and stabilizers and all that so I can test printing it, but any tips on that?

Do you just change the things in parameters.scad then re-render? The main struggle right now is adding the MCU and getting the whole board to be one pcb piece, as it currently splits it into a few pieces - I think due to spacing being more than some threshold. Also, is there any easy way to split this into two pieces when doing a more standard board like this? My 3d printer won't fit the whole thing, but I could maybe do that after everything else is done in Fusion or something.

I've attached the keyboard layout as a txt file as github isn't allowing JSON.

Thanks, Kyle

keyboard-layout.txt

[KyleStiers]

Here is an image of the current keyboard.scad that is generated

[AndyChiu]

Hi, you can try this file layout.scad.txt