3d-gussner

@bryn51 I will close this issue, if you still think it is relevant please feel free to reopen it.

@fitch22 Thanks for the bug report, but we merged https://github.com/prusa3d/Prusa-Firmware/pull/1263 quite long time ago and it should have fixed the issue.

@fitch22 FW 3.13.3 was mainly a bug fix for Ghost layer shifts and with minimal changes it got tested very fast. Any other changes would have delayed the important release.

Closing due to lack of interaction.

@arekm I assigned this PR to myself and will discuss this with the development team.

@Panayiotis-git First test looks good. The M117 message is shown correctly during M600. :tada: - [X] MMU3 print :heavy_check_mark: It behaves the same as before - [X] MMU3 print with...

Here some test pictures with my changes in French as it is one of the messages that "normally" exceeds the limit of 20 char. First Change with `M117 Deep Blue`...

@Panayiotis-git Thank you so much to provide a new PR for your initial awesome idea from 19 December 2019. Impressive that you are still willing to work on this 4...

@gudnimg Do you have an idea how we can not spend 21 bytes of RAM?

@Panayiotis-git and @sarusani The previous PR #2380 has been rejected as it would need changes in PrusaSlicer by adding a parameter to `M600` . So not sure if a change...