3Dangel

You should not import the file, instead you need to open the folder where your FW is located. Check YT how to Mks Sbase, it is the same way. Also,...

I think it is on the platformio.ini Where you have to comment out that line. On Fri, Nov 29, 2019 at 07:35 wedgevic wrote: > I did not understand it...

https://github.com/MarlinFirmware/Marlin/issues/16159 take a look hope this helps

你們好， 若貴公司可以錄制how-to 基本設定 及自動水平功能和所使用的硬體，這樣，可幫助不少使用貴公司的Robin 板 的客戶。 祝 你們大伙 萬事如意 Robert Calgar, AB On Mon, Oct 22, 2018 at 04:26 makerbase wrote: > Hello, can you please improve your problem? After...

One thing you are not mentioning is what type of sensor you are using for your Z. Also on the picture, you have Two red cable in. What are they?...

I believe that is the problem. Usually, tit is either an end stop , it an auto leveling. Your sensor needs to have positive, negative (or ground) and SIG. I...

here is from repetier's site info about the auto leveling. https://www.repetier.com/documentation/repetier-firmware/z-probing/ I personally, stop using it, since I know how/when/ what to look for leveling my bed at very begining...

I see... So it has to do something in the TFT touch screen and the main board that can not recall the file name and show it on screen..... It...

again .... I think the usage of the Bed-Leveling _ Method 2 should accompany for points as: >Z_PROBE_X1 50 #coordinateX1 is preset point >Z_PROBE_Y1 90 #coordinateY1 is preset point >Z_PROBE_X2...

just putting here that the new MArlin 2 is now fully dupported on this MKS Robin